Tu piszą podobnie:
http://www.bmwe34.net/E34main/Trouble/TransProgram.asp
Cytuj:
Things to check before even contemplating a transmission overhaul:
Check electrics - Alternator and battery.
Replace DME Relay and Fuel Pump Relay - not expensive.
Remove disassemble, clean and reassemble gear selector switch - If it looks beyond saving, replace ($200)
Service the transmission ($130 from a specialist) and check/replace transmission speed sensor ($90)
Cytuj:
"The trans program usually refers to the line pressure and its relationship to the pressure valves in the transmission. If you have quite a few miles on the vehicle the filter may be clogging and with sudden turns or accleration, the fluid pressure may drop and then be noticed by the trans. module. "
"Sometimes it is an electrical issue, like the thermostat temp sensor went bad - sent bad info to the computer - and wouldn't let car start."
"Fluids dropped in the center console caused it to come on briefly. Turned off the car and waited a while, car started fine and never saw the message again."
"I had this occur once when pulling away from a stopped position on an incline. I realized later I had my hand resting on the shifter which slipped it into neutral in error, and when I revved the engine, I panicked... the car started to roll back then I slammed it into Drive, which it didn't like, and it gave me "Trans. fail/safe prog" message. I turn the car off for few minutes and it has been fine ever since."
"Question posted: My car went into transmission fail safe program. None of the gears work including R and 4. Would anybody know what could cause this?"
z "innego forum"
http://www.bmw-klub.pl/forum/viewtopic. ... 7c4ca5a806